Interlogix VDP-MSP Series - Manual (Page 7)

P/N 1069680 • REV 1.0 • ISS 14APR10 7 of 12
Power: Connect the power input connectors to the external class II power supply.
Make sure that the power requirement is within the recommended range. Turn
on the external power supply.
GEC-8VPDCHUB and GEC-16VPDCHUB
Turn off external power supply.
Video: Connect each RJ-45 video connector to a Cat-5 cable carrying 4 video
signals to the control room.
Data: Connect each RJ-45 data connector to a Cat-5 cable carrying 4 data
signals to the control room.
Camera Cable: Connect each camera RJ-45 connector to the appropriate
camera Cat-5 cable.
Power: Make sure that the power requirement is within the recommended range.
Connect the AC power cord to the AC power outlet and turn on the power switch
to the unit.
Control Room Installation
Video: Connect each Cat-5 cable carrying 4 video signals to the Active Receiver
Hub. If Cat-5 is terminated in RJ-45, use provided RJ-45 adapter for the
connection.
Data: Connect each Cat-5 cable carrying 4 data signals to a DVR or PTZ
controller.
Diagnostic LEDS
GEC-4DVDPC and GEC-16VDPC
There is one diagnostic LED per channel:
Green LED:
OFF: No camera is connected
ON: Camera is connected and current flows
GEC-8VPDCHUB and GEC-16VPDCHUB
There are 2 diagnostic LEDs per channel: