Zero point (initial position) setting, Display settings – Interlogix TruVision 960H Premium Resolution Series PTZ Cameras Configuration Manual User Manual
Page 13
Chapter 2: Programming
TruVision Analog PTZ Camera Configuration Manual
11
4. Click the up/down buttons to increase/decrease the value.
5. Click
IRIS+
button to confirm and exit.
Zero point (initial position) setting
You can define the initial position of the PTZ camera using the
Zero Point Setting
submenu
.
To change the zero point setting:
1. Go to
Main Menu
>
System Settings
>
System Infor Settings
.
2. Use the direction buttons to move the cursor to
Zero Point Setting
and click
IRIS+
to enter.
3. Click the left/right/up/down buttons to adjust the monitor angle of the PTZ camera
to find the initial position.
4. Click
IRIS+
button to confirm and exit.
Display settings
You can enable or disable the on-screen display for the information of zoom, PTZ
movements, alarms, time, presets, zone, address, error rate, and fan and heat, etc. See
Figure 3 below.
Figure 3:
Display settings menu