Interlogix TruVision PTZ Mini 12X User Manual - Manual (Page 13)

1BChapter 2: Installation
TruVision Mini PTZ 12X Camera User Manual 9
Figure 3: Dome camera DIP switches
Indoor dome camera Outdoor dome camera
A. Dome camera protocol DIP switches
B. RS-485 communication DIP switches
C. None
D. 22-pin connector
E. Dome camera site ID DIP switches
F. Reserved
G. Reserved
See the following sections on how to setup the ID and control protocol of the dome
camera.
Setting up the dome camera
To quickly put the Mini PTZ 12X dome camera into operation:
1. Configure the dome camera’s DIP switches, which are located on the top of the
dome camera.
2. Set the dome camera communication protocol.
3. Set the RS-485 communication DIP switch.
4. Verify and set the communication termination, if required.
5. Set the dome camera ID.
6. Mount the dome camera to the wall/ceiling.
7. Wire the dome camera.
8. Connect the dome camera to a monitor.
9. Program the dome camera.