Interlogix NVR 20 Quick Start - Manual (Page 8)

EN ‐ 6 TruVision NVR 20 Quick Start Guide
TVN 20 Browser - Adding IP cameras
The TVN 20 supports a wide variety of Interlogix IP
cameras including a single channel encoder in addition
to a variety of IP cameras supplied by other
manufacturers (such as Axis and Arecont). Please refer
to the latest TVN 20 IP Camera Compatibility Chart for
the most current listing of supported devices.
There are two ways to add IP cameras:
• Using Quick Add feature based upon auto-discovery
protocols.
• Manual Add when an IP camera does not support
auto-discovery protocols.
It is recommended to use Quick Add first and then use
manual add for those cameras not discovered.
Quick Add
1. Login in to the TVN 20 using the default User Name
and Password.
2. The TVN 20 Browser will display the default Live
(Preview) page.
3. Click on the Config tab at the top.
4. The Config window will be displayed in the Remote
Config mode. The display will not show any IP
cameras.
5. Click on the Quick Add button at the bottom of the
page.
6. The display will show all of the “discovered” IP
cameras.
7. Click the checkbox next to each of the cameras you
wish to add to this specific TVN 20 unit.
8. Once all desired cameras have been selected, click
Ok.
9. The system will return you to the main Config page
with all of the cameras you selected populated into
the unit.
10. All of the cameras have been added with default
settings. These default settings are:
• VGA resolution
• Full Frame Rate
• Recording 24x7