Interlogix IS-ZW-AM-1 - Manual (Page 3)

equipment uses, generates and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communication. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipement and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Operation is subject to the following two conditions:
• This device may not cause interference, and
• This device must accept any interference, including
interference that may cause undesirable operation of the
device.
Note: To comply with the FCC RF exposure compliance
requirements, no change to the antenna or the device is
permitted. Any change to the antenna or the device could result in
the device exceeding the RF exposure requirements and void the
user’s authority to operate the device.
FCC ID: U2Z45602-3
IC: 6924A-45602A3
Model: 45603
This Class B digital device complies with Canadian ICES-003.
Contact information
For contact information see our Web site: www.gesecurity.com.
P/N 1069503 • REV A • ISS 16NOV09 3 of 4