Interlogix NX-148E-RF - Manual

P/N 466-2198 • REV F • OCT12
NX-148E-RF LCD Touchpad with Receiver
Installation Instructions
Content
Contact information 1
Product summary 1
Installation 2
Transmitter programming 2
Touchpad programming 5
Reference tables 9
Specifications 14
Regulatory information 14
Contact information
www.utcfireandsecurity.com or www.interlogix.com
For customer support, see www.interlogix.com/customer-
support
© 2012 UTC Fire & Security Americas Corporation, Inc.
Interlogix is part of UTC Climate Controls & Security, a unit of
United Technologies Corporation.
All rights reserved.
Product summary
The NX-148E-RF Touchpad with Receiver combines touchpad
and receiver capabilities into a single device for use with all
NetworX control panels except CF (commercial fire) panels.
Note: When using this touchpad with an NX-8E, NX-8V2, NX-
6V2, or NX-4V2 and downloading via modem, make sure the
control panel version is equal to or greater than the following
versions:
• NX-8E 17.00
• NX-8V2 1.04
• NX-6V2 1.05
• NX-4V2 1.04
Make sure you are using DL900 version 2.11 or greater
software.
Installation guidelines
Use the following installation guidelines:
• Mount transmitters as close as possible to the touchpad.
For best results, we recomm end the distance between the
transmitter and the touchpad be less than 100 ft. (30.5 m).
• Mount the touchpads in an environmentally controlled area
with a temperature range from 32 to 120°F (0° to 49°C).
• When mounting the touchpad, allow at least 3 in. (7.6 cm)
below the touchpad for the swing-down door ( Figure 1 ).
Figure 1. Side view
• Use Table 1 to determine the maximum wire lengths
allowed between the touchpad and the panel.
Tools and supplies needed
• Pencil
• Phillips screwdriver
• Drill
• 15/64 in. drill bit
• Mounting screws (provided)
• Wall anchors (optional)
• 4-conductor, 22, 18, 16, 14 or 12-gauge wire (see Table
1 ).