Interlogix NX-148E-RF - Manual (Page 6)

6 NX-148E-RF LCD Touchpad w ith Receiver Installation Instructions
Service menu (2)
A Service Required message will display periodically if the
system requires service. To access the service menu, do the
following:
1. Enter * 2 to display one or more of the fault messages in
Table 9 .
2. Press or to scroll through the messages.
3. To exit the service messages, press # #.
View alarm memory (3)
To view alarm memory, do the following:
1. Enter * 3.
2. Press or to display the alarm memory list in sequential
order by zone number.
3. To exit, press #.
Test function (44)
If programmed, the test function will do a battery test,
communicator test, and/or a siren test. No alarms will be sent.
To test the system, do the following:
1. Enter * 44.
2. To exit, press #.
Display test function (45)
To test display functions, do the following:
1. Enter * 45. All display pixels and LED indicators will flash,
but no alarms will be sent.
2. To exit, pres s #.
Light control for X10 (46)
To control up to ten X10 devices from each touchpad (when
used with an X10 device such as an NX-507E, NX-508E, NX-
534E or NX-540E), do the following:
1. Enter * 46. The display prompts you to Select Light
Number 0-9.
2. Enter the X10 device number you want to control.
3. Press or to turn the selected device on or off.
4. Repeat steps 2 and 3 until all devices have been
programmed.
5. To exit, press #.
Unit and house codes for X10 (47)
To program the specific X10 unit and house codes for the X1 0
devices for this touchpad (when used with an X10 output
device such as an NX-507E, NX-508E, NX-534E or NX-540E),
do the following:
1. Enter * 47.
2. Enter your program code.
Note: Use * key to select light number.
3. Enter the X10 unit number (see Table 5 ) and press *.
Table 5. X10 m odule numbers and unit numbers
X10
module
number
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Unit
number
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
6. Enter the X10 house code (see Table 6 ) and press *.
Table 6. X10 house codes
0 = A 4 = E 8 = I 12 = M
1 = B 5 = F 9 = J 13 = N
2 = C 6 = G 10 = K 14 = O
3 = D 7 = H 11 = L 15 = P
7. To exit, press #.
Change languages (49)
This function allows you to toggle between the two languages
programmed in your touchpad. To change languages, do the
following:
1. Enter * 49. The touchpad toggles to the second language.
2. Enter * 49. The touchpad toggles to the first language.
3. To exit, press #.
Change user codes (5)
For partitioned systems, to change the user code of another
person you must have access to all or more partitions than the
user being changed. To change the user code, do the
following:
1. Enter * 5.
2. Enter your master code.
3. Enter the user number you want to change.
4. Enter the new user code.
5. To exit, press #.