Interlogix ESL DH Series - Manual (Page 2)

2
Installing the Door Catch Assembly
With the electromagnetic assembly securely fastened,
aligned, and energized, proceed with the installation of the
door catch assembly.
Step 1:
Separate the alignment template
from the mounting template.
Step 2:
Place the swivel catch plate
against the magnet. Make sure it
is centered over the magnet.
Step 3:
With the catch plate attached to
the magnet, peel the backing off
of the mounting template, and
slide it over the base of the door
catch. Make sure the adhesive
side is facing the door.
Step 4:
Gently open the door until it
touches the base of the door
catch. Adjust the base until it lies
flat against the door.
Step 5:
While applying slight pressure on
the door, slide the mounting
template over the base to the door
surface, and apply pressure to the
template in a few spots.
Step 6:
Gently close the door to expose
the mounting template. Apply
final pressure to the mounting
template to ensure it is securely in
place.
READ INS TRU CT IO N S
READ IN STR UC TI O N S
1.750" 44.45mm
1.750" 44.45mm
Step 7:
Insert the alignment template into
the center of the mounting template.
Use the tab to rotate the alignment
template for a fine adjustment.
While holding the alignment
template in the door.
Step 8:
If you are using the optional door
back plate for hollow doors,
center punch the points indicated on
the alignment template for either
horizontal or vertical installation.
For best results, drill an 1/8 inch
diameter pilot hole, and then a 5/16
inch diameter hole.
If you are installing the door
catch assembly directly to a solid
door, drill an 1/8 inch diameter
pilot hole approximately 1 to 1 ½
inch deep. Be careful not to drill
through the door.
Step 9:
Remove only the alignment
template from the door.
Place the base of the door
READ IN STR UC TI O N S
1.750" 44.45mm
READ IN STR UC TI O N S
Note: If door extension rods are
required, install them before you
proceed with this procedure.
Step 10:
Secure the door catch assembly in place with the two
retaining screws, and remove the mounting template.
Step 11:
Test the door holder to make sure it is operating properly.
Place the door in the hold (open) position. If the door shuts,
check the alignment of the catch plate and magnet. Also,
check to make sure the power is turned on at the control
panel and the magnet is energized.
catch in the center of the
mounting template. Align
the screw holes on the base
with the dots on the
mounting template.