ISP Technologies BETA BASS - Manual (Page 3)

FRONT PANEL
1. INPUT JACK
This ¼-inch mono jack provides the high impedance for connection to your bass .
2. GAIN
Adjust gain until the red LED barely flashes.
3. BASS
Controls the low frequency level.
4. MIDRANGE 1
Controls the low/midrange. BOOST/CUT controls the level at the frequency selected by the FREQ
control. Bandwidth switch selects wide/narrow bandwidth.
5. MIDRANGE 2
Controls the high/midrange. BOOST/CUT controls the level at the frequency selected by the FREQ
control. Bandwidth switch selects wide/narrow bandwidth.
6. TREBLE
Controls the high frequency level.
7. BRIGHT SWITCH
Adds extra high frequency boost.
8. EXCITER
Adds high frequency transparency by altering the harmonic structure.
9. DECIMATOR NOISE REDUCTION THRESHOLD
Controls the level at which the noise reduction takes effect.
10. COMPRESSOR THRESHOLD
Controls the level at which the compressor takes effect.
11. MASTER VOLUME
Controls the level of the main outputs. When the rear panel switch is set to POST, this control will
also affect the level of the direct output.
12. POWER SWITCH
Turns the power on or off.