ISP Technologies BETA BASS - Manual (Page 4)

REAR PANEL
1. 9VAC POWER INPUT JACK
Supplies power to the unit by plugging in a 9V AC adaptor.
2. PRE/POST CONTROL
Controls the source of the DIRECT OUTPUT. PRE takes the DIRECT OUTPUT before the MASTER
VOLUME control and POST takes the DIRECT OUTPUT after the MASTER VOLUME control.
3. GROUND LIFT CONTROL
Disconnects the ground pin (#1) of the DIRECT OUTPUT. This is useful for solving hum
problems.
4. DIRECT LEVEL CONTROL
Controls the level of the DIRECT OUTPUT.
5. DIRECT OUT
Use this output to feed a mixing console.
6. MAIN OUT (XLR)
Use this output to feed the active speaker cabinets.
7. MAIN OUT (1/4 inch)
Use this output to feed the active speaker cabinets.
8. FOOTSWITCH (1/4 inch TRS)
The tip controls the EXCITER on/off and the ring controls the COMPRESSOR on/off.
9. SEND (1/4 inch)
Connect to the input of an external Effects device.
10. RETURN (1/4 inch)
Connect to the output of an external Effects device.
11. EFFECTS LEVEL
Controls the level of the external effect.