Desa Tech CGEFP33PR - Manual (Page 19)

19 107570
OWNER’S MANUAL
For more information, visit www.desatech.com
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS
(CGEFP33PR)
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to HIGH, check to see
if flames contact any log. If so,
reposition logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
INSTALLATION
Continued
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Locate pegs on the bottom of back log (#1).
Slide these pegs into the holes in the grate
base behind the burner (see Figure 40).
Figure 40 - Installing Back Log (#1)
Figure 41 - Installing Middle Log (#2)
Figure 42 - Installing Front Log (#3)
Hole in
Grate Base
Figure 43 - Installing Crossover Log (#4)
Back
Log (#1)
Burner
Crossover
Log (#4)
Rectangular
Knobs
2. Place the base of the middle log (#2) in
the U-shaped slots of the grate base in
front of the back log. The cutout on the
right of the middle log should fit over the
burner (see Figure 41). Make sure the
front of the middle log is resting on the
tabs of the grate base and the cutout area
is centered over the burner “U” bend.
3. Locate the recesses on the back of the
front log (#3). Fit these recesses between
the posts of the grate base (see Figure 42).
4. Locate the notches in the bottom of the
crossover log (#4). Place the crossover log
on top of the middle log and front log.
Make sure the notches of the crossover log
lines up with rectangular knobs on top of
the middle and front logs (see Figure 43).
Burner
Tab
Middle Log (#2)
U-Shaped
Slot
“U” Bend
Cutout
Front Log (#3)
Post
Recess
Post
WARNING: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS (EFP33PR)
CAUTION: Do not remove the
warning and instruction labels
attached to the heater base as-
sembly. These markings contain
important warranty information.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
Continued