Unvented propane/lp gas fireplace, Installation, Continued – Desa Tech CGEFP33PR User Manual

Page 20

Advertising
background image

20

107570

UNVENTED PROPANE/LP GAS FIREPLACE

For more information, visit www.desatech.com

Figure 48 - Installing Fireplace Screen

WARNING: You must operate

this fireplace with the fireplace
screen in place. Make sure fire-
place screen is in place before
running fireplace.

Install fireplace screen by slipping notches
of fireplace screen over screws on front of
fireplace (see Figure 48).

INSTALLING SCREEN

Figure 47 - Installing Crossover Log (#4)

Crossover Log (#4)

Peg

Recess

Figure 45 - Installing Back Log (#2)

Figure 46 - Installing Front Log (#3)

Back Log (#2)

Peg

Peg

Front Log (#3)

Grate Fingers

Notches

1.

Place the base of the middle log (#1) in
the U-shaped slots of the grate base.
The cutout on the right of the middle
log should fit over the burner (see Fig-
ure 44). Make sure the front of the
middle log is resting on the tabs of the
grate base and the cutout area is cen-
tered over the burner “U” bend.

2.

Locate pegs on the bottom of back log (#2).
Slide these pegs into the holes in the grate
base behind the burner (see Figure 45).

INSTALLATION

Continued

Figure 44 - Installing Middle Log (#1)

Middle Log
(#1)

"U"-shaped
Cutout in
Base

Burner

3.

Locate the notches in the bottom of the
front log (#3). Place the front log on
the grate fingers. Make sure the notches
of the front log line up with the grate
fingers (see Figure 46).

4.

Place crossover log (#4) onto the peg
(right) on back log (#2) and into the re-
cess of the middle log (#1) (see Figure 47).

INSTALLING BATTERY INTO
REMOTE

1.

Locate slot at bottom of remote con-
trol (see Figure 49). Firmly insert tool
such as a small screwdriver, butter
knife, or dime into the slot and lift up
to remove cover.

2.

Insert supplied battery into remote
control. Positive and negative are
marked inside remote control casing.

Note:

Remote will not function if bat-

tery is not installed correctly.

3.

Slide tab on cover into remote housing
and snap cover back into place.

Notches

Screws for Mounting
Screen

Positive

Figure 49 - Installing Battery

Negative

Tab

Cover

Remote
Control

Slot

Advertising
This manual is related to the following products: