Cisco OL-14587-01 - Manual (Page 14)

Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Adding Phones to the Cisco Unified Communications Manager Database
2-14
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 6.1
OL-14587-01
Related Topics
• Adding Phones with Auto-Registration, page 2-12
• Adding Phones with Cisco Unified Communications Manager
Administration, page 2-14
• Adding Phones with BAT, page 2-14
Adding Phones with Cisco Unified Communications Manager
Administration
You can add phones individually to the Cisco Unified Communications Manager
database using Cisco Unified Communications Manager Administration. To do
so, you first need to obtain the MAC address for each phone.
For information about determining a MAC address, see the “Determining the
MAC Address of a Cisco Unified IP Phone” section on page 2-15 .
After you have collected MAC addresses, in Cisco Unified Communications
Manager Administration, choose Device > Phone and click Add New to begin.
For complete instructions and conceptual information about Cisco Unified
Communications Manager, refer to Cisco Unified Communications Manager
Administration Guide and Cisco Unified Communications Manager System
Guide.
Related Topics
• Adding Phones with Auto-Registration, page 2-12
• Adding Phones with Auto-Registration and TAPS, page 2-13
• Adding Phones with BAT, page 2-14
Adding Phones with BAT
Cisco Unified Communications Manager Bulk Administration Tool (BAT), a
standard Cisco Unified Communications Manager application, enables you to
perform batch operations, which includes registration, on multiple phones.
Before you can add phones using BAT only (not in conjunction with TAPS), you
must obtain the MAC address for each phone.