Philips PCA460RW User Manual
Cdrw400
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Table of contents
Document Outline
- IlllllinillllllllllllllllUllllli
- LASER SAFETY
- CLASS 1
- LASER PRODUCT
- CAUTION
- CAUTION
- FOR EUROPE
- Table of Contents
- Introduction
- Recording Modes
- Chapter 1.
- System Configuration
- Chapter 2.
- Installing your Philips CD Rewriter Drive
- Rear Panel
- Setting your Philips CD Rewriter as the MASTER
- Setting the Philips CD Rewriter as the SLAVE
- CSEL (Cable SELect)
- Installing your Philips CD Rewriter drive
- 1. Switch off your computer, and unplug it from the mains power outlet.
- 2. Remove the cover from your computer.
- 3. Your hands or body may be holding a charge of static electricity.
- 4. Remove the front cover of a vacant half-height drive bay.
- 5. Slide your Philips CD Rewriter into the drive bay from the front.
- 6. Connect the IDE interface connector.
- Connect the AUDIO cable.
- AUDIO cable
- 8. Connect the power supply cable.
- 9. Tighten the four fastening screws securely.
- 10. Re-attach the cover to the computer.
- 11. Connect the power cable to an AC outlet, and switch on your computer.
- 12. Start up your operating system.
- 13. Install your Philips CD recording software
- Chapter 3. Operation
- Front Panel
- 1 Disc tray
- 2 Headphone jack
- 3 Headphone volume control wheel
- 6 Eject button
- 7 Manual Eject port
- Loading a Disc
- Ejecting the Disc
- If your Philips CD Rewriter is powered-up:
- If your Philips CD Rewriter is not powered up:
- Manual Eject (emergency use)
- 1. Insert the pin-like tool into the manual eject port and push gently.
- After manually ejecting a disc, you must turn off the power supply to your Philips CD Rewriter, then turn it back on before continuing.
- Troubleshooting
- Appendix