Connect the ide interface connector, Connect the audio cable – Philips PCA460RW User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
6. Connect the IDE interface connector.
Connect the 40-pin IDE interface connector to the IDE interface located on the rear
panel of your Philips CD Rewriter drive.
Position the connector so that the colored line is at pin 1 (your lower right).
Connect the AUDIO cable.
Connect the single 4-pin connector (Sound Blaster compatible) to the sound card.
Connect the 4-pin connector at the other end of the cable (the larger connector) to the
AUDIO OUT connector on your Philips CD Rewriter drive. The polarizing lug should
be at the top.
Chapter 2 • InstaUing yt»ur Philips CD (tewriter 11
Advertising