Canon IP ReadyTM Series Video Alarm FDP75C12N - Manual (Page 3)

-  -
!
!
ELECTRICAL SPECIFICATIONS (OUTDOOR ONLY):
Power 12Vdc, Class 2 Only
Total Power: 21 watts Housing only
Accessories (Heater/Blower): 21 watts
Heater: 20 watts
Blower: 1 watt
NOTE: This unit is designed for operation in an
upright position. Installing the housing
upside down may cause damage to
the internal equipment, and will void the
warranty.
Be sure the bracket is properly and securely mounted
to a supporting structure capable of rigidly holding
the weight of the entire unit.
GENERAL INSTRUCTIONS:
Tools Required: .100" Flat Head Screwdriver
Phillips Head Screwdriver
FDW75C12N, FDP75C12N
IP Ready Network Housing
IP Ready Network Housing with 12Vdc input, wall mount or
pendant mounting, heater & blowers, ready for standard IP
PTZ cameras.
ASSEMBLING THE UNIT:
Remove content from all boxes. Contents should include:
Main Housing Assembly
Either with wall mount or pendant bracket
Dome Assembly - Clear or Tinted
Do not remove the protective film until the product is
assembled and installed.
3 Packet Assemblies
CARE AND CLEANING OF DOMES:
All FDW75 and FDP75 units include an optically clear
polycarbonate dome. The dome is an optical device and
should be handled with extreme care. Leave protective film
on dome until product is fully assembled and installed. Even
though the dome is virtually unbreakable, it can be easily
scratched.
Clean only with a clean cotton cloth and warm water.
DO NOT use a strong solvent or cleanser!