Philips AZ1509-17 - Manual (Page 8)

POWER SUPPLY
Batteries
For the set (optional):
Open the battery compartment of the set and insert six batteries,
type R20, UM1 or D-cells (preferably alkaline).
For the remote control (supplied):
Open the battery compartment of the remote control and insert two
batteries, type R03, UM4 or AAA-cells (preferably alkaline).
Remove the batteries if they are dead or if the set will not be used
for a long time.
Batteries contain chemical substances, therefore they
should be disposed of properly.
AC power
1 Check whether the voltage shown on the type plate corresponds.
to your local voltage. If it does not, consult your dealer or
service organization. The type plate is located on the base
of the set.
If the set is equipped with a VOLTAGE selector (g), set this
selector to the local voltage.
2 Connect the power cable to the AC MAINS inlet and the wall
socket. This switches on the power supply. The cable is
inside the battery compartment.
The battery supply will be switched off when the set is connected
to a power supply. To change over to battery supply, remove the
plug from the unit's AC MAINS socket.
To disconnect the set from the completely, remove the power plug
from the wall socket.
To avoid overheating of the set a safety circuit has been built in. Therefore your
set may switch off under extreme conditions. If this happens, release the
POWER button and let the set cool down before reusing it.
8