Philips 46CE8761 - Manual (Page 21)

General
What to do in case of faults
• If the TV does not give the desired
result \when used, check that the power
is on, the aerial is connected and that
all the controls are set correctly.
• If there is no sound, check whether
the button i!5 for sound interruption
has been pressed or switch OFF ON is
in the correct position.
• if there is no picture, check that the
VIDEO RGB - RGB switch is in the
VIDEO RGB position.
• If a bright white line appears on the
TV screen, or the TV indicator lamps
start to flash when you are not
operating any of the controls, then
switch off the TV and switch it on again.
If this does not achieve the required
result, consult your dealer.
In order to get the longest possible
service from your remote control, we
advise you to handle it carefully and to
avoid dropping or knocking it. If the TV
no longer reacts to commands given
with the remote control, then the
batteries are probably flat. Replace
them. It is advisable to use Philips
Alkaiine batteries, type LR03.
• The rear panel of the set may be
• Whenever moving, always keep the
set in an upright position.
Cleaning the projection TV
The projection TV must only be cleaned
with a damp chamois leather. Do not
use alcohol, spirits, ammonia or
abrasive cleaning agents.
It is advisable to rub the chamois
leather up and down the screen {i.e.e
not from side to side).
Technical information
Direct TV channel selection
• Press button C/P.
The indicator CH appears briefly on the
screen followed by a two or three-digit
number (on the hyperband model).
• Select the required channel number
with the digit buttons.
Euroconnector specifications
exter­ exter­
nal 1 nal 2
Pin IB- 2B-
1 audio output (right channel) 0.5 Vrms/1 kohm X X
2 audio input (right channel) 0.5 Vrms/10 kohms X X
3 audio output (left channel) 0.5 Vrms/1 kohm X X
4 audio earth connection X X
5 B input earth connection X
6 audio input (left channel) 0.5 Vrms/10 kohms X X
7 B input 0.7 Vpp/75 ohms X
8 remote control signals
+'status input (EXT 1) 0-2/10-12V/10 kohmsX X
9 G input earth connection X
10 not connected
11 G input
0.7 Vpp/75 ohms X
12 not connected
13 R input earth connection
X
14 not connected
15 R input
0.7 Vpp/75 ohms X
16 fast blanking input 0-0.4V/1-3V/75 ohmsX
17 CVBS earth connection X X
18 fast blanking earth connection X
19 CVBS output 1 Vpp/75 ohms X X
20 CVBS input 1 Vpp/75 ohms X X
21 cover X X
17