Philips CDR 765 - Manual (Page 17)

RECORDING
Start digital recording
1 With the recorder stopped, press RECORD to enter the
Record standby mode.
RECORD flashes.
linmiim I i-i' wo f'''
COS.uC
III., in '.-i-uifi.c sc'"i
/«'tin .
r,'*:
fi- ^ 0M3
II II -
il li ïuTi^i rîv Tj^;c<nv:
Il lî
• If
DIG
also flashes, the digital connection is incorrect.
2 To start recording, press PLAY on the CD Recorder/Player
and immediately start the source (from the stop mode).
RECORD
lights continuously. The track number and
recording time used will be indicated on the display.
• To record a three-second pause (silence) at the beginning of
a track, press PAUSE on the CD Recorder/Player.
• To check the (remaining) recording time, press DISPLAY.
(This can also be done during the recording.)
3 To stop recording, press STOP on the CD Recorder/Player.
RECORD will
go out.
• To interrupt recording, press PAUSE.
-> RECORD
starts to flash. Resume at step 2.
After recording the display will show LIPo'RhE for several
seconds.
Note: With auto track on, the recorder will stop
automatically. Recordings from DAT or DCC will stop
after 20 seconds silence. With auto track off, the auto
STOP mode is disabled.
Synchronized digital recording from an
external CD player - CD-SYNC
Preparing for synchronized digital recording
The CD-SYNC feature enables you to make fast and easy
digital recording of a CD. Track increments are automatically
detected from the digital source material. Track increments
cannot be added manually.
1 Make sure the disc is absolutely free of scratches and dust
particles.
2 Press SOURCE repeatedly until (depending on the
connection used);
DIG d IS ItRL
or
DIG
uPt ISRL will appear on the
display.
• If necessary, press DUAL to switch off the
dual
mode;
DUAL will no longer appear on the display.
IFtcDfol rtFÂÏël WO rf.AC< O'.
Q
tS
Q
IÏÏÏCTI TR:C<
Ihr.'AULfci CD?-;;c ssc
0U2Ô1 S’-tFFlE SCA'.
H II
SHUFFLE
AUTOm:C< TOTA'- T pw.Trs II II TOTAL HcM Ttnc< TiVs
n II
.¡2
‘
to
B
LU
Start synchronized digital recording
1 With the CD Recorder/Player stopped, press CD-SYNC.
On the display,
cd - sync
&
SdRC
appear. After a
time,
RECORD
starts to flash.
SRC
SI'Lffti
If ;wu26i COSYNC
DUB31 SKUFF1.E SCAII
AUTOTSAC:
Q Q
0 D
II It
TOm ftEM TfAC-.TIVi n II TOTAL fit.' TFAt\ TlVE
o U n r n II
_i _i M II II
■ OO O’T r-=nO TfA-.-Tl
II II TAIKF poni KIPA.-.TI
• If
DIG
also flashes, the digital connection is incorrect.
2 To start recording, press PLAY on the external digital
source.
The CD Recorder/Player automatically starts to record
and
RECORD
lights continuously. The track number and
recording time used will be indicated on the display
• If you start the source during a track, CD-SYNC will not
start recording until the beginning of the next track.
15