Crimestopper Security Products Series IV Super Rage CS-2011RS - Manual (Page 13)

TRANSMITTER PROGRAMMING
Note: Remotes Transmitters come pre-programmed from the Factory. When re-learning remotes or
adding remotes, ALL your system’s remote codes must be learned at time of programming!! This
system allow storage of up to 4 different remote codes in memory.
1. Open hood (ground the Blue hood pin wire if no hood pin is installed.)
2. Turn key to the ON position. (Starting the vehicle is not necessary.)
3. Press Program/Valet button 4 times. After a few seconds, the unit will flash the parking lights 4 times.
4. Press Button #1 (Lock) of the transmitter to be learned. You should get 2 light flashes indicating the code-
learn. Now the unit is waiting for a 2 nd code, so repeat this step as needed with up to 3 additional remotes.
The unit will flash the lights in succession after each code learned for up to 4 codes. (2 flashes for the 2 nd
code, 3 flashes for the 3 rd code etc.) If all 4 codes are learned, the unit will automatically exit code learning
mode, otherwise turn key OFF and close the hood.
IGN
OFF
WAIT FOR
4 FLASHES
PRESS 4X's
FLASH 2, 3, or 4 X's
(BLUE WIRE GROUNDED)
IGN
OFF
START
13