Crimestopper Security Products Series IV Super Rage CS-2011RS - Manual (Page 14)

2 VEHICLE OPERATION
The CS-2011RS Series IV system can be used for 2 car operation. A single remote can control two
independent vehicles with an identical systems installed.
See diagram below for car #2 operation. Follow the “Transmitter Programming” steps on the second vehicle.
Program Car #2’s existing remotes, then quickly press the Car #2 side button on your remote before pressing
the lock button on your remote to program it to Car #2.
NEW Push-Button 2-Car method: Your remote may have a push-button on the side in place of a slide-
switch for 2-car operation. Please read the following: Your remote must be programmed to the second vehicle
first. Press the side button on your remote first, and within 3 seconds, press any of the 4 function buttons on
your remote. You can keep pressing function buttons to control car #2 as long as it is within the 3-second
window. After 3 seconds have elapsed, the remote will revert back to Car #1 control.
START
CrimeStopper
VEHICLE #2
Press side button
first, then you have
4 seconds to
control vehicle #2.
14