Philips QC5055 - Manual (Page 5)

To Charge/Recharge
I
Fully charge Clipper before using for the first
time or after non-use for a long period of time.
I Battery performance is best if you recharge
only when the battery is (almost) completely
empty.
I Charging, recharging, or using Clipper at
temperatures below 40°F or higher than 95°F
adversely affects lifespan of the battery.
I Continuously recharging Clipper will reduce
lifespan of battery.
D
Be certain Clipper is OFF.
D
Insert the appliance plug directly into
the Clipper and plug the adapter into any
120V AC outlet (fig 1). Use only the cord
provided.
B After a few moments, the Charging Light on
the appliance will light to indicate the Clipper
is charging (fig. 2).
k It will take approximately 10 hours to fully
charge the Clipper for a cordless clipping
time of up to 35 minutes.
NOTE: After the Clipper is fully charged, the
Charging Lisjht will remain lit.
□ Disconnect the cord and unplug from
electrical outlet.
Optimize the working life of the battery
I
After the Clipper has been charged for the first
time, do not recharge the Clipper between
clipping sessions. Continue using it until the
battery is completely empty.
I
Do not charge for more than 24 hours.
I
Do not keep cord permanently plugged in.
I
Discharge/run down the battery completely
twice a year by letting the motor run until it
stops.
k If the Clipper hasn’t been used for a long
period of time, it must be recharged for a
full 10 hours.
Corded Hair Clipping
k Only use the Clipper corded when the battery
is empty.
k Clipper does not recharge during corded
clipping.
Q Connect cord provided to clipper and plug
clipper into electrical outlet (fig. 1).
B
If battery is completely empty, wait a few
minutes before switching clipper ON.
B
Slide ON/OFF switch ON to begin clipping.
□ Turn clipper OFF and unplug.
Cordless Hair Clipping
B Charge according to directions. Unplug
Clipper from outlet and remove cord.
B
Slide ON/OFF switch ON to begin clipping.
B
If the charge runs out while clipping, simply
connect cord provided to Clipper and outlet
to continue clipping.