Chief Manufacturing PF1 Series - Manual (Page 6)

MF1, MF2, PF1, PF2 Series Installation Instructions
6
ASSEMBLY
CAUTION: Attachment holes may be damaged if a power
drill is used to insert button head cap screws. Screws should
first be inserted and turned BY HAND with the hex key or with
a handheld screwdriver BEFORE using the hex head drill bit
and power drill to complete the attachment.
Assembling Base for Single Display Stand
1. Attach top base section (A) to the center post (F) using four
5/16-18 x 1-1/2" buttonhead cap screws (N) and four 5/16"
flat washers (Q). (See Figure 1)
Figure 1
NOTE: Ensure that post (F) front is placed to the front of base
section (A). Check for "FRONT" on base section (A).
(See Figure 1)
NOTE: Insert and tighten screws in order shown (1, 2, 3, 4) in
Figure 2.
Figure 2
2. Gather stand base pieces B and C (2) as shown in Figure 3
and push them together until the edges meet.
Figure 3
3. Place top base section and center post assembly on top of
the three base pieces with the center post front facing base
pieces (C). (See Figure 4)
4. Fasten lower base pieces (B and C) to top base section and
center post assembly using twelve 5/16-18 x 1/2" flat head
cap screws (L). (See Figure 4)
Figure 4
Assembling Base for Dual Display Stand
1. Follow Step 1 (and Figures 1 and 2) of Assembling Base
for Single Display Stand.
2. Gather four base pieces (C) as shown in Figure 5 and push
them together until the edges meet.
2
1
NOTE: To help
determine front of
base - distance (1)
is shorter than
distance (2).
(F)
(Front)
(A)
[labeled "FRONT"]
1 (N) x 4
(Q) x 4
1
2
1
2
4
3
(B)
(C)
(B)
(C)
(L) x 12 4
(F)
(Front)