Cobra Electronics Radar Detector - Manual (Page 8)

Operation
15
Operation
14
Memory Set
This product features an automatic, internal
electronic memory system. It will automatically
“remember” your settings when the unit is
turned off or removed from the power source up
to 7 days.
Memory Set
Auxiliary Audio Jack
Use to co n n e ct an exte rnal spe a ker to your Co b ra
ESD-9550 in env i ro n m e nts with high ambient noise
l eve l s.The inte rnal spe a ker will be disco n n e cte d.
Auxiliary
Audio Jack
The message “Drive in 2 circles…
press City when done. ” will then be displayed.
Drive your car in a circle twice and then press
City. Your compass will be set. The display
provides 8 primary directions;N,NE, E, SE, S,
SW, W and NW.
Note
Your compass may not give
a correct reading if you are
inside any enclosure,
building or close to a large
metal tractor trailer, truck or
train. Your compass will
work again correctly as
soon as you get away from
these locations. There is no
need to calibrate your
compass again.
Calibrate
Compass Calibrate Compass
The compass in your ESD-9550 must be calibrated
before you use it to give accurate directions.
Calibration allows the compass electronics to
measure and store information about the
magnetic fields from your vehicle.
Press City button for a minimum of
2 seconds. Compass is displayed.
Note
Pushing City button for
more than 2 seconds
produces a single beep
confirmation tone.
Note
If you decide to re-locate
your ESD-9550 to a different
location in your vehicle or
move it to another vehicle, it
is best to recalibrate the
compass.
1
2
Selecting Manual Muting Mode
In Manual Mute mode the alerts will always be
heard at the set volume le vel.
Press and release Mute Button when no
signal is being received. M u t e will appear on
the display for 2 seconds, then disappear.
1
Auto Mute will appear in display for 2 seco n d s,
then disappe a r. All future alarms will be Au to Mu te.
Muting
*9550.MANUAL 8/9/00 12:21 PM Page 14