Chaparral K5312/K7313 - Manual (Page 110)

G- and K-Series User’s Guide
8-2
Displaying Drive Information
You can display two types of information about disk drives:
!
A list of all drives connected to the controller
!
The status of all drives in an array
Displaying All Drives
You can display a list of all drives connected to the controller. The information
includes:
!
Channel
!
SCSI target ID
!
Size
!
Manufacturer
!
Model number
!
Drive firmware revision
If any of the drives are members of an array, the following information may also
display:
!
Utility running—Expand, Verify, etc.
!
Array number—this array’s sequential position in the controller’s array list
!
Member number—this drive’s sequential position in the array
Drives that are not members of any array are listed as Available. Drives that contain
leftover metadata from a previous array are listed as Leftover. This situation can arise
if drives are pulled and reinserted. To clear left over metadata, use the Clear Metadata
function. See Clearing Metadata from a Drive on page 8-4.