Canon Multimedia Projector LV-8235 UST - Manual (Page 13)

13
⑦ CONTROL PORT
When controlling the projector with RS-232C,
connect the control equipment to this connector
with the serial control cable.
⑧ 3D SYNC OUT
Connect a 3D sync. signal cable for an IR wireless
emitter to this jack (p.50)
⑨ LAN Connection Terminal
Connect the LAN cable (refer to the user's manual
of "Network Set-up and Operation").
⑩ COMPUTER IN 1/COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal (pp.18, 20).
⑪ COMPUTER IN 2/MONITOR OUT
This terminal is switchable and can be used
for input from a computer or output to the other
monitor.
Set the terminal up as either Computer input or
Monitor output properly. [Used for Monitor out,
this terminal outputs only incoming signal from
COMPUTER IN 1/COMPONENT IN terminal (pp.
18, 58)].
⑫ HDMI
Connect the HDMI signal from computer or video
equipment to this terminal (pp.18, 20).
① S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.19).
② VIDEO IN
Connect the composite video output signal to this
jack (p.19).
③ AUDIO IN
Connect the audio output signal from video
equipment connected to  or  to this jack. For
a monaural audio signal (a single audio jack),
connect it to the L (MONO) jack (p.19).
④ COMPUTER 1/COMPONENT AUDIO IN
Connect the audio output (stereo) from a computer
or video equipment connected to ⑩ or ⑫ to this
jack (pp.18, 20).
⑤ COMPUTER 2 AUDIO IN
Connect the audio output (stereo) from a computer
connected to ⑪ to this jack (pp.18, 20).
⑥ AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.18-20).
This terminal outputs sound from AUDIO IN
terminal (
③, ④ or ⑤) or HDMI terminal ⑫ (digital
audio).
Never plug headphones and earphones into
AUDIO OUT jack.
Part Names and Functions
①
Side Terminal
② ③ ④ ⑥ ⑤ ⑦ ⑧
⑨ ⑩ ⑪ ⑫