Curtis AR-B1682 - Manual (Page 13)

~ Page 7 ~
2-2. COMPONENT LOCATIONS
AR-B1682 Connector, Jumper and Component Locations
2-3. HOW TO SET JUMPERS
A jumper consists of two or three metal pins with a plastic base mounted on the card, and a small plastic cap
(with a metal contact inside) to connect the pins, so you can set up your hardware configuration by
"open" or
close the pins. The jumper can be combined into sets which called jumper blocks. When the jumpers are all
in the block, you have to put them together to set up the hardware configuration. The figure below shows how
it looks.
2 PIN 3 PIN
CAP
JUMPERS AND CAP
If a jumper has three pins, for example, labelled PIN1, PIN2, and PIN3, you can either connect PIN1 & PIN2 to
create one setting and shorting or connect PIN2 & PIN3 to create another setting. The jumper setting rules are
applied throughout this manual.
CN13
CN16