Jaypro Sports PBEL96 - Manual (Page 18)

ELITE Series Adjustable Portable Backstop Instructions
- 14 of 27-
JSL-Inst039
www.jayprosports.com
2. ONLY IF BACKBOARD IS INSTALLED, remove the quick-release pin
from the height adjuster mechanism (Figure 7-1).
3. Stand to one side of the unit and lift one of the two handles on the
lower upright (Figure 8-2).
a. If raising the backstop is too strenuous obtain assistance
before attempting to raise.
b. Be sure to maintain control of the uprights while raising. Do
not release handle while raising.
Figure 8-2: Lift handle on lower upright.
4. Raise backstop to maximum height (the uprights will reach a hard
stop and will be fully vertical).
c. Insert the quick-release pin into the height adjuster.
5. Verify that the top of the rim is at a height of 10 feet off the ground.
d. If the rim is not at 10 feet, adjust both feet (be sure to
maintain level side-to-side) until it is.
e. Ensure that both side and front horizontal 2x4’s of the base
are level (Figure 6-2).
6. With the backstop still set to 10’, verify that the board is still plumb. If
not, adjust according to the procedure in section 0 (step 7).
7. Set both foot stops to the bottom of the openings in the front of the
base and tighten both setscrews using the 5/64” hex wrench (Figure
8-3).