Jaypro Sports PBEL96 - Manual (Page 25)

ELITE Series Adjustable Portable Backstop Instructions
- 21 of 27-
JSL-Inst039
www.jayprosports.com
10 Installing Floor Anchor and Locator Bushings
The holes for the floor anchor and locator bushings are located in
reference to both the baseline of the court as well as the centerline
perpendicular to the baseline.
1. Locate holes. There are two options for locating the holes for the
anchor and locator bushings.
Option 1:
Locate the holes according to the diagram below that is appropriate
for your backstop model:
a. PBEL54 (54” overhang): refer to Figure 10-1
b. PBEL66 (66” overhang): refer to Figure 10-2
c. PBEL96 (96” overhang): refer to Figure 10-3
Option 2:
a. Position the backstop such that it is centered on court and the
front surface (padding removed) is the correct distance from the
baseline (see figure below, distance varies depending on
model).
b. Use the transfer punch to locate holes for locator bushings.
c. Locate hole for FP-90 floor anchor such that there will be some
slack in the chain when installed to anchor point at rear of PBEL
base frame.
2. Follow the instructions included with the PBELKIT to install the FP-100
floor anchor.
3. Drill the holes for the locating bushings using the 1-1/8” hole saw.
Drill all the way through the floor surface.
4. Sand the inside surface of the hole and the outside surface of the
bushing.
5. Clean and dry all sanded surfaces.
6. Liberally apply adhesive to surface of the drilled hole only.
7. Press the bushing into the hole until it is approximately 1/16” below
the floor surface.
8. Clean up any adhesive residue according to manufacturer’s
instructions.