Jaypro Sports FBGP-720 - Manual (Page 4)

T:\Aftermarket\Football\Drawings\FGBP-720\DOCUMENTATION\FBGP-720 Installs.doc
REV D 4/10 3
crossbar is level, mark (by using a center punch) and drill the holes through the
gooseneck. Start with a 3/16” bit, then a 3/8” bit and finally a ½” bit.
Mark and Drill Crossbar:
Once the holes are drilled, use the ½” bolts with two flat washers and thin lock nut. Use
a Silicon sealant used on each side of the bolt to prevent corrosion.
Tightening ½” bolts between crossbar and gooseneck: