Jaypro Sports FBGP-720 - Manual (Page 5)

T:\Aftermarket\Football\Drawings\FGBP-720\DOCUMENTATION\FBGP-720 Installs.doc
REV D 4/10 4
Top Upright Installation:
Place the end fitting in the end of the crossbar and plumb to level in two directions – front
to back and side to side. Mark the holes using a center punch. IMPORTANT: It is
important that the holes in the end fitting be properly placed to ensure that the end fittings
are square and the uprights are parallel to each other.
Remove the end fitting and drill the marked holes. Start with a 3/16” bit, then a 3/8” bit
and finally a ½” bit.
Drill End Fitting:
Insert the end fitting in crossbar and loosely install the appropriate hardware. Verify that
the vertical member is square to the crossbar and plumb.