Jaypro Sports FBGP-600 - Manual (Page 6)

5
Remove the end fitting and drill the marked holes. Start with a 3/16” bit, then a 3/8” bit
and finally a ½” bit.
Drill End Fitting:
Insert the end fitting in crossbar and loosely install the appropriate hardware. Verify that
the vertical member is square to the crossbar and plumb.
Attach top upright cap:
Install the upright cap on the top upright. The cap goes on the end without holes. Tap
the cap in place and drill a 1/8” through the hole on the cap to the top upright. Uses the
self-tapping screws provided and secure the cap.