Canon IMAGE RUNNER 5065 - Manual (Page 48)

TCP/IP Network Setup Procedures 3-2
3
Usin
g a
TCP/IP Netw
or
k
TCP/IP Network Setup Procedures
To use a TCP/IP network, it is necessary to perform the following procedures.
1
Protocol Settings (See "Protocol Settings," on p. 3-3.)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
Canon utilities (NetSpot Device Installer, etc.)
2
Computer Settings for Printing/Sending a Fax (See "Setting Up a Computer for Printing/
Sending a Fax," on p. 3-43.)
Specify the settings for each computer you use for printing or sending a fax. (Optional equipment is required
to print or send a fax from a computer. For the equipment needed, see "Optional Equipment and System
Requirements," on p. 1-2.)
3
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p. 3-57.)
Specify the settings of the computer receiving data sent from the machine. (Optional equipment is required to
send data from the machine. For the equipment needed, see "Optional Equipment and System
Requirements," on p. 1-2.)
IMPORTANT
• If you are using the optional imagePASS, for step 2, see the manual provided with the
optional imagePASS, not this guide.
• It is recommended that steps 1 and 3 above be performed by the network administrator.
• The machine or optional printing equipment does not come with printer driver software
that can be used on a UNIX platform. (Use LPD to set up a printer in UNIX.)
• As the fax option does not come with fax driver software for the UNIX platform, it is not
possible to send a fax from a UNIX platform.