Cobra Electronics XRS9430 - Manual (Page 6)

Dim Button
Press and release
City Button
Press and
release
Settings
Intro Operation Customer
Assistance
Warranty
Notice
Secondary Icons
Your Detector
Nothing Comes Close to a Cobra ® 7
UltraBright Data Display Brightness
You can choose from three settings for Brightness of the display.
You can cycle through the settings by repeatedly pushing the Dim button.
The factory setting is Bright.
Settings
Intro Operation Customer
Assistance
Warranty
Notice
Secondary Icons
Your Detector
6 English
Highway/City Mode
Setting your detector to City mode delays all X band audio alerts until
the signal strength reaches Level 3. (A single beep will sound when the
signal is first detected.) This will reduce false alerts while you are driving
in, or near, urban areas where there are many sources for conflicting
X band signals such as microwave towers and automatic door openers.
To change settings, follow the procedure listed below, which indicates
what you will see and hear (either in Voice Alert or Tone Alert mode)
as you complete each step. The factory setting is Highway mode.
Bright
Dark
Dim
Press and
release Dim
button
City Mode
X K Ka V S c
Highway Mode
X K Ka V S
h
To Change From Highway Mode to City Mode
Press and release
the City button. Tone Voice Visual Display
One beep City c appears
in the display
To Change From City Mode Back to Highway Mode
Press and release
the City button again. Tone Voice Visual Display
Two beeps Highway h
appears
in the display
To Change the Brightness to Dim
Press and release
the Dim button
once. Tone Voice Visual Display
One beep Dim Display dims
To Change the Brightness to Dark
Press and release
the Dim button
again. Tone Voice Visual Display
One beep Dark Display remains
dim (no visual
alerts will be seen)
To Change the Brightness to Bright
Press and release
the Dim button a
third time. Tone Voice Visual Display
Two beeps Bright Display returns
to full brightness