Chief Manufacturing LCD Swivel Stand MSS6000 User Manual

Page 5

Advertising
background image

Installation Instructions

MSS6000

5

INSTALLATION

Mount Installation

Free Standing (not anchored) Applications Only:

NOTE:

Do not perform this step if you are going to anchor the
stand to a surface.

1.

Install five rubber bumpers (B) on bottom of stand. (See
Figure 1)

Figure 1

Display 24 Inches High or Smaller:

1.

Loosen the four height adjustment screws and raise
the slide to its maximum height. (See Figure 2)

2.

Secure the slide by tightening the four height
adjustment screws.

Figure 2

Display More Than 24 Inches High:

NOTE: The MSS-6000 comes pre-configured for displays

24” in height or less. If a display with a height
greater than 24" is being installed follow the
instructions below.

To install a display with a height greater than 24":

1.

Remove slide plate assembly from the base by
removing four

5/16-18 x 3/4" button head cap screws

, and

four 1/4" flat washers. (See Figure 3)

Figure 3

2.

Remove face plate from slide plate assembly by
removing two 3/8"-16 x 1" round head carriage bolts,
two 1" OD x .563 ID spacers, two 3/8" flat washers,
and two 3/8-16 lock nuts. (See Figure 5)

3.

Reinstall face plate into upper mounting holes of slide
plate using two 3/8"-16 x 1" round head carriage bolts,
two 1" OD x .563 ID spacers, two 3/8" flat washers,
and two 3/8-16 lock nuts removed in Step 2. (See
Figure 5)

4.

Reinstall slide plate assembly onto base using four

5/16-18 x 3/4" button head cap screws

and four 1/4" flat

washers previously removed in Step1. (See Figure 3)

5.

Raise slide plate assembly to maximum height.

6.

Secure slide plate in place by tightening the four
height adjustment screws. (See Figure 2)

Figure 4

View from Bottom

Rubber Bumpers
(5 places)

Faceplate Height Adjustment Screws (4)

x 4

x 4

1

Slide
Plate
Assembly

Base
Assembly

4

x 4

Face
Plate

Slide
Plate

Carriage Bolt

Spacer

Flat
Washer

Lock
Nut

Advertising