Chief Manufacturing LCD Swivel Stand MSS6000 - Manual (Page 8)

MSS6000 Installation Instructions
8
Figure 9
Display Swivel Tension Adjustment
Display swivel tension is pre-set at the factory. Swivel
tension will vary depending on the weight of display being
mounted.
If swivel tension adjustment is required:
1. Disconnect all cords and cables from display.
2. Follow steps in Removing Display from Mount
section.
3. Lay mount on back. (See Figure 10)
4. Locate three tensions adjustment screws.
(See Figure 10)
5. Turn each adjustment screw either clockwise to
increase tension, or counter-clockwise to decrease
tension.
NOTE: It is important that all adjustment screws are
turned equal amounts in the same direction for
the display to turn properly.
6. Install display following the instruction outlined in
Display Installation section on page 6.
7. Test display swivel tension by grasping each side of
display and turning display left and right.
If additional swivel tension adjustment is required, repeat
steps 1 through 7 above.
Display Swivel Stop Location Adjustment
The MSS-6000 allows for the installation of swivel stops
that limit the amount of display travel. Stops can be
installed at +/-15, 25 or 35 degrees.
To install swivel stops:
1. Follow steps 1 through 3 of Display Swivel Tension
Adjustment section.
2. Insert one 10-24 X 1/2” Phillips head cap screw in one
of the three swivel stop holes (15, 25 or 35 degrees)
in the base of the stand. (See Figure 11)
Figure 10
Figure 11
Roll Adjustment Nuts
(2 places)
NOTE: Adjustment nuts located between slide plate and
back plate of base assembly.
2 deg. Max.
Tension Adjustment Screw
(Turn left to decrease tension
Turn right to increase tension)
15 degrees 35 degrees
25 degrees