Chief Manufacturing MSR Series - Manual (Page 6)

Installation Instructions MSR Series
6
ATTACH MSB TO THE DISPLAY
To attach the MSB to the display, do the following:
To help your identify the correct MSB that matches
the model number of your display, refer to the cross-
reference chart at
www.chiefmfg.com .
To download the corresponding MSB installation
instructions, refer to
www.chiefmfg.com .
OR
Contact Customer Service at 952-582-6480 if you
have any questions about how to select the MSB that
matches the model number of your display.
INSTALL THE DISPLAY
IMPORTANT! Display size may impact the ability to
effectively reach the latching flag. If this is the case
install the optional “Latching Flag Extension kit”
provided with mount and reinstall display. See
“Latching Flag Extension Installation” below.
To install the display, do the following:
NOTE: Verify that all power/audio/video cables are
disconnected and MSR latching flag is in the
“down” position before attempting to mount
the display.
1. With the aid of another person, lift the display up to
the mount (10) on the wall, aligning mounting
buttons with the teardrop slots on the mount, and
lower the display firmly into place (see Figure 6).
2. Raise latching flag to secure the display (see Figure
7). If the flag does not fully engage, check to ensure
the mounting buttons are fully seated in the slots.
NOTE: A padlock may be installed through the hole in
the latching flag for additional security.
REMOVE THE DISPLAY
To remove the display from the mount, do the following:
1. Disconnect all power/audio/video cables.
2. Lower the latching flag to unlock the display.
3. With the aid of another person, lift the display up and
out of the teardrop slots in the mount to remove the
display.
Figure 6. Install the Display
Figure 7. Raise Latching Flag to Lock
Latching Flag
Teardrop Slot
Lock
Unlock
MSR Mount
Display
MSB