Clarion ADB341MP - Manual (Page 18)

20
ADB340MP/ADB341MP
280-7740-00
8. SPECIFICATIONS
FM Tuner
Frequency Range:
87.9 MHz to 107.9 MHz (ADB340MP)
87.0 MHz to 108 MHz (ADB341MP)
Usable Sensitivity: 11 dBf
50dB Quieting Sensitivity: 17 dBf
Alternate Channel Selectivity: 75 dB
Stereo Separation (1 kHz): 35 dB
Frequency Response ( ± 3 dB): 30 Hz to 15 kHz
AM Tuner
Frequency Range:
530 kHz to 1710 kHz (ADB340MP)
531 kHz to 1629 kHz (ADB341MP)
Usable Sensitivity: 25
µ
V
CD Player
Frequency Response (
±
1 dB): 10 Hz to 20 kHz
Signal to Noise Ratio (1 kHz): 100 dB
Dynamic Range (1 kHz): 95 dB
Harmonic Distortion: 0. 01%
Tape Deck
Wow & Flutter (WRMS): 0.06 %
Channel Separation (1 kHz): 45 dB
Frequency Response (
±
3 dB)
120 µ s (normal): 30 Hz to 18 kHz
Audio
Maximum Power Output:
200 W (50 W
×
4 ch) (JEITA)
Continuous Average Power Output:
17 W
×
4, into 4 , 20 Hz to 20 kHz, 1%THD
Bass Control Action (100 Hz):
±
10 dB
Middle Control Action (1 kHz):
±
10 dB
Treble Control Action (10 kHz):
±
10 dB
Line Output Level (CD 1kHz): 1.8 V
General
Power Supply Voltage:
14.4 V DC (10.8 to 15.6 V allowable),
negative ground
Current Consumption: Less than 15 A
Speaker Impedance:
4
Ω
(4
Ω
to 8
Ω
allowable)
Weight / Source unit: 4.6 lb. (2.1 kg)
Dimensions / Source unit:
7" (Width)
×
3-15/16" (Height)
×
7 -1/4" (Depth)
[178 (W)
×
100 (H)
×
183 (D) mm]
Notes:
• Specifications and design are subject to change
without notice for further improvement.
7. ERROR DISPLAYS
If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
If an error display other than the ones described above appears, press the CD eject button for more
than 10 seconds to reset. If the problem persists, turn off the power and consult your store of purchase.
Measure
This is a failure of CD deck’s mechanism
and consult your store of purchase.
Replace with a non-scratched,
non-warped-disc.
Eject the disc then reload it properly.
This is a failure of Tape deck’s mechanism
and consult your store of purchase.
Error Display
ERROR 2
ERROR 3
ERROR 6
ERROR
Cause
A CD is caught inside the CD deck and is
not ejected.
A CD cannot be played due to scratches,
etc.
A CD is loaded upside-down inside the CD
deck and does not play.
Tape is caught and cannot be ejected.
CD
T
ape
03.12.17, 0:08 PM 20