Canon DR-4080U - Manual (Page 51)

49
Error Message Table
Possible Cause Remedy LCD
Rollers are dirty. Clean the rollers. ( ➞ 38)
* * * W a r n
C l e a n R o
i n g * * *
l l e r
Rollers require replacement. Replace the rollers.
* * * W a r n
R e p l a c e
i n g * * *
R o l l e r
Double-feed occurred. Check the ADF paper feed path.
* * * W a r n
D b l F e e d
i n g * * *
O c u r r e d
Page has jammed. Remove the jammed page. ( ➞ 36) U 1 1 J A M
✕ ✕ ✕ ✕ ✕ ✕ ✕ ✕
Page has jammed. Remove the jammed page. ( ➞ 36)
Originals are still in the scanner. Remove all documents in the ADF.
U 1 2 J A M
✕ ✕ ✕ ✕ ✕ ✕ ✕ ✕
Dust on the document sensors. Clean the document sensors. ( ➞ 41)
U 1 8 R e m a i n d D o c .
✕ ✕ ✕ ✕ ✕ ✕ ✕ ✕
Double-feed occurred. Remove the jammed pages. ( ➞ 36) U 2 3 D o u b l e F e e d
✕ ✕ ✕ ✕ ✕ ✕ ✕ ✕
Front door is open. Close the front door. U 3 0 F r o n t D o o r
✕ ✕ ✕ ✕ ✕ ✕ ✕ ✕
ADF door is open. Close the ADF door. U 3 1 A D F D o o r
✕ ✕ ✕ ✕ ✕ ✕ ✕ ✕
Imprinter (top door) is open. Close the imprinter door. U 3 2 T o p D o o r
✕ ✕ ✕ ✕ ✕ ✕ ✕ ✕
Document cover is open. Close the document cover. U 3 5 D o c . C o v e r
✕ ✕ ✕ ✕ ✕ ✕ ✕ ✕
Service error*. Switch off the scanner, unplug the
power cord, and call for service.
Interface board not installed. Install the interface board.
F ✕ ✕ C a l l S e r v i c e
✕ ✕ ✕ ✕ ✕ ✕ ✕ ✕
U 5 0 N o I ⁄ F B o a r d
✕ ✕ ✕ ✕ ✕ ✕ ✕ ✕
* If you see the call-for-service error “F41 Call Service” displayed in the LCD, check the position of the metal
clamp under the scanner. (
➞ 10)
Troubleshooting