Installation instructions, Locating your fireplace, General – Vermont Casting ACSM User Manual

Page 3

Advertising
background image

3

The Vermont Castings Majestic Products Company

1.

Read all instructions before using this appliance.

2.

This appliance is hot when in use. To avoid
burns, do not let bare skin touch hot surfaces. If
provided, use handles when moving this
appliance. Keep combustible materials,such as
furniture, pillows, bedding, papers, clothes, and
curtains at least 3 feet (1 m.) from the front of
this appliance.

3.

CAUTION: Extreme caution is necessary
when any heater is used by or near children
or invalids and whenever the heater is left
operating unattended.

4.

If possible, always unplug this appliance when
not in use.

5.

Do not operate any heater with a damaged cord
or plug or after the appliance malfunctions, has
been dropped or damaged in any manner.

6.

Any repairs to this fireplace should be carried

out by a qualified service person.

7.

Under no circumstances should this fireplace be
modified. Parts having to be removed for
servicing must be replaced prior to operating
this fireplace again.

8.

Do not use outdoors.

9.

This heater is not intended for use in bathrooms,
laundry areas and similar indoor locations. Never
locate this appliance where it may fall into a
bathtub or other water container.

10.

Do not run cord under carpeting. Do not cover
cord with throw rugs, runners or the like.
Arrange cord away from traffic areas and where
it will not be tripped over.

11.

To disconnect this appliance, turn controls to
the off position, then remove plug from outlet.

12.

Connect to properly grounded outlets only.

13.

This appliance, when installed must be
electrically grounded in accordance with local
codes, with the current CSA C22.1 Canadian
Electrical codes or for USA installations, follow
local codes and the National Electrical Code,
ANSI/NFPA NO. 70.

INSTALLATION INSTRUCTIONS

14.

Do not insert or allow foreign objects to enter
any ventilation or exhaust opening as this may
cause an electric shock, fire, or damage the
appliance.

15.

To prevent possible fire, do not block air intakes
or exhaust in any manner. Do not use on soft
surfaces, like a bed, where openings may
become blocked.

16.

This appliance has hot and arcing or sparking
parts inside. Do not use it in areas where
gasoline, paint, or flammble liquids are used or
stored. This fireplace should not be used as a
drying rack for clothing, nor should Christmas
stockings or decorations be hung on or near it.

17.

Use this appliance only as described in this
manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or
injury to persons.

18.

Avoid the use of an extension cord because the
extension cord may overheat and cause a risk
of fire. However, if you have to use an extension
cord, the cord shall be No. 16 AWG minimum
size and rated not less than 1900 Watts. The
extension cord must be a three wire cord with
grounding type plug and cord connector.

19.

SAVE THESE INSTRUCTIONS.

LOCATING YOUR FIREPLACE

Your new freestanding electric fireplace may be

installed virtually anywhere in your home. However,

when choosing a location for your new fireplace,

ensure that the general instructions are followed.

Also, for best effect, install the fireplace out of direct

sunlight.

GENERAL

Advertising
This manual is related to the following products: