Cardo SCALA RIDER G4 - Manual (Page 12)

Searching for and saving new stations
Radio station pre-sets can be saved using the Cardo Upgrades PC
software or directly from your G4 device.
There are two ways to search for a new radio station on your G4:
Seek and save:
1. While the Radio is on, select the station number from one to six
that you wish to set by tapping the CHANNEL “B” button until the
desired station is found.
2. Press and hold the Volume Up or Volume Down Button for three
seconds.
• Pressing Volume Up will search upwards (higher frequency).
• Pressing Volume Down will search downwards (lower frequency).
3. Once a station is found, searching stops and you can hear the
station.
4. To continue searching, press the Volume Up or Volume Down Button
again for three seconds.
5. Tap the CHANNEL “B” button within 20 seconds of finding the
station to save the current station.
6. If you don’t save the station, the Radio will exit search mode
without saving the current station. You can still continue to listen
to the current unsaved station. Tapping the CHANNEL “B” Button in
this case will move to the next saved station.
Scan and save:
1. While the Radio is on, select the station number from one to six
that you wish to set by tapping the CHANNEL “B” button until the
desired station is found.
2. Press and hold the Volume Up button for 6 seconds.
3. The device will begin to Scan by searching upwards for the
next station. Once a station is found, searching pauses for a few
seconds while you hear the current station and then the G4 will
automatically continue to the next station.
4. To stop Scanning and stay on the current station, tap the Volume
Up Button again.
5. Tap the CHANNEL “B” button within 20 seconds of finding the
station to save the current station.
6. If you don’t save the station, the Radio will exit search mode
without saving the current station. You can still continue to listen
to the current unsaved station. Tapping the CHANNEL “B” Button in
this case will move to the next saved station.
NOTE: Press CHANNEL “B” button during radio Scan to Fast Save the current
station directly into the Preset Channel number you were last listening to.
Automatic Radio Tuning: Automatically search for and find 6 new
“on the go” radio stations with one button press.
This feature makes finding new stations fast and easy by creating a
temporary list of “on the go” radio stations.
While the radio is on, press and hold the Volume Down Button for 6
seconds, and the G4 will search upwards from the current frequency
and store the next 6 FM stations it discovers as “on the go” stations.
You can repeat this process as many times as you wish, searching for
the next 6 FM stations each time.
Now you can cycle through these stations by tapping the CHANNEL
“B” button.
NOTE: These 6 temporary “on the go” stations cannot be saved and do not
replace the permanent Saved Radio Stations you may have set using the
“Saving a selected station” procedure. Turning OFF and ON the G4 will clear
out your Automatic Radio Tuning stations, and restore the original saved
radio stations.
12 scala rider ® G4 PowerSet