Cardo SCALA RIDER G4 - Manual (Page 21)

En
gli
sh
Initiate Intercom calls from scala rider G4
There are two ways to start an Intercom call with your paired headsets
while the G4 is in Standby mode:
VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an
Intercom call will be established with
both paired headsets.
The Intercom call will stay on until all
participants remain silent for 30 seconds.
CHANNEL BUTTON
CONNECT:
Single tap the chosen
Channel Button to add or
remove the unit from an
Intercom call.
Initiate Intercom calls from:
Q2
pro
: Tap the MC Button once on a Q2
pro
unit to open an intercom
call. To terminate the call, tap once.
Q2: Tap the MC Button twice on a Q2 unit to open an intercom call.
Wait 3 seconds between taps. To terminate the call, tap once.
Other scala rider models: Tap the headset CTRL Button to open/
close intercom call.
9.11c. THREE WAY INTERCOM WITH OTHER SCALA RIDER
MODELS
In terms of range, the 3-Way Intercom between your G4 and
other scala rider units achieves distances of the lowest common
denominator. For example, connecting your G4 with two Q2
pro
units
will enable intercom distances of maximum 2,300 ft / 700m.
NOTE: When connected to earlier scala rider headsets (e.g. a “Solo”, “FM”,
"TeamSet pro " or a “TeamSet” Driver unit) only Rider-to-Passenger mode is
available.
All options are in Full Duplex, meaning that all parties can speak and
hear one another simultaneously, similar to mobile or landline phone
conversations and unlike walkie-talkie communications.
Using the G4 with two Q2/Q2
pro
headsets:
Proceed with setup as in section 9.11a above and use either in Rider-
to-Passenger or in Bike-to-Bike mode.
Using the G4 and scala rider Q2/Q2
pro
with either a Solo, FM,
TeamSet
pro
or TeamSet (Driver) headset:
Q2/Q2
pro
: Proceed with setup as in section 9.11a above and use in
Bike-to-Bike mode.
Solo, FM, or TeamSet (Driver): Proceed with setup as in section
9.11b above but use only in Rider-to-Passenger mode.
Example:
To pair your G4 with a Q2 and an FM headset:
1. Pair your G4 with the Q2 as described in section 9.11a., using
CHANNEL “A”.
2. Pair your G4 with the FM as described in section 9.11b., using
CHANNEL “B” (For Rider-to-Passenger use only).
Using your G4 with another G4 and another scala rider model
(such as a Q2/Q2
pro
, Solo, FM, TeamSet
pro
or TeamSet [Driver])
1. Proceed with setup as in section 9.10b above for pairing the
second G4.
2. Proceed with setup as in section 9.11a or 9.11b above according
to the headset you want to use.
Example:
To pair your G4 with another G4 and a scala rider FM headset:
1. Pair your G4 with the second G4 as described in section 9.10a.,
using CHANNEL “A”.
2. Pair your G4 with the FM as described in section 9.11b., using
CHANNEL “B” [For Rider-to-Passenger use only].
21 scala rider ® G4 PowerSet