Country Flame CF-04 - Manual (Page 26)

Version 2.0e 26
shroud can be moved left, right, or centered on the Crossfire depending on the requirements of
the hearth. The installer should make final adjustments to properly locate the top shroud on the
Crossfire and then tighten the two nuts. The top shroud is now properly positioned and secured
in place and the installer can proceed to install the left and right shroud panels.
FIGURE 11a: CROSSFIRE SHROUD (rear view)
3. Remove the two washers and ¼- 20 nuts from the right shroud panel (right is defined as the right
side when FACING the Crossfire) as shown in FIGURE 1 and FIGURE 2. Position the right
shroud panel onto the studs. One stud is located on the right side of the hopper, FIGURE 1, and
one stud is located at the base of the right Crossfire side door, FIGURE 2. The right shroud
panel (top edge) should overlap the top shroud panel on the FRONT side of the stove. Secure
the right shroud panel in place by installing the two washers and two ¼-20 nuts that were
previously removed. Make final adjustments of the right shroud panel and then tight the two
¼-20 nuts as shown in Figure 11b. Repeat this process to install the left shroud panel. Shroud
panel installation is now complete.
FIGURE 11b: CROSSFIRE SHROUD (right bottom view)