Country Flame CF-04 - Manual (Page 32)

Version 2.0e 32
MOBILE HOME INSTALLATION
WARNING: DO NOT INSTALL A COUNTRY FLAME CROSSFIRE STOVE IN ANY MOBILE
HOME SLEEPING ROOM.
WARNING: THE STRUCTURAL INTEGRITY OF THE FLOOR, WALL, CEILING AND ROOF
MUST BE MAINTAINED DURING THE INSTALLATION OF A COUNTRY
FLAME CROSSFIRE STOVE IN A MOBILE HOME.
WARNING: A CROSSFIRE STOVE INSTALLED IN A MOBILE HOME MUST BE COMPLETED
IN ACCORDANCE WITH 24 CFR, PART 3280 (HUD).
WARNING: A CROSSFIRE STOVE MUST BE PERMANENTLY BOLTED TO THE FLOOR OF
THE MOBILE HOME.
WARNING: A CROSSFIRE STOVE MUST BE ELECTRICALLY GROUNDED TO THE STEEL
FRAME OF A MOBILE HOME.
MOBILE HOME RULES
1. Install only a HUD-approved laboratory tested stove in a mobile home. If the metal tag permanently
affixed to a pellet burning stove does not specifically state; “mobile home approved to HUD Standard
UM-84,” do not install the product in a mobile home. The Crossfire Model CF-04 is approved for use
in mobile homes. Install all Crossfire stoves in accordance with 24 CFR, part 3280 (HUD).
2. A permanent (hard line) combustion fresh air duct system must be installed and connected from the
outside of the mobile home directly to the combustion air inlet on a Crossfire stove.
3. A Crossfire stove must have a listed prefabricated chimney system installed in the mobile home. This
chimney system must be properly connected and installed directly from the stove through the roof of
the mobile home using only one manufacturer’s chimney products. Follow the chimney
manufacturer’s installation instructions to the letter.
4. All mobile home stove installations or stove replacements require a permit to be obtained from the
local code department and at least a final inspection before operation of the stove is authorized. Use
only licensed contractors to perform the installation work. Further, an insurance representative
should provide an approval document stating that the installation and inspection are in accordance
with industry standards and therefore covered by the homeowner’s insurance policy.
MOBILE HOME CLEARANCES
1. Clearance is defined as the open space distance between any part of the stove or its flue connector and
any combustible material, including but not limited to: walls, ceilings, trim moldings, furniture, word
storage containers, or any other combustible item. Refer to the stove clearance section of this manual
or the certification tag on a stove for minimum clearances that must be maintained during installation
of a stove into a mobile home.
2. Use of an approved thermal barrier may allow for the reduction of no barrier minimum stove
clearances. Remember that a wall (wood studs covered with sheetrock, even if that wall is covered
with brick) is still considered combustible. Functional thermal barriers are made of hearth pads
consisting of two ¼” sheets of mineral board or 24-guage sheet metal spaced 1” from the combustible
wall, with approved spacers that provide additional protection to the combustible wall. Refer to a
hearth pad manufacturer’s instructions or the National Fire Protection Association Publication 211.