Charge indications low battery, Charging, To charge / recharge – Philips QT4050-41 User Manual

Page 3: Corded trimming

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Charging

Charge the Trimmer fully before you start using it

for the first time or after a long period of non-use.

Charge Indications

Low Battery

I When the battery is almost empty

(approximately 7 or fewer trimming minutes
left), the battery light turns orange.

I When you turn off the Trimmer, the battery

light blinks orange for a few seconds.

Charging

► When you start charging, the battery light

blinks green.

ft When the battery is fully charged, the battery

light lights up green continuously.

To Charge / Recharge

ft (Re)charging requires approximately 8 hours,
ft Use only the cord provided,
ft Charging, recharging or using the Trimmer at

temperatures below 40°F or higher than 95°F

adversely affects lifetime of battery,

ft You may also trim using the cord provided,
ft IfTrimmer hasn't been used for a long period

of time,Trimmer must be recharged for
approximately 8 hours.

D Be certain Trimmer is OFF.

B Connect cord to Trimmer (fig. 1). Plug into

any 120V AC outlet only. Use only the cord

provided.

ft An adaptor plug may be necessary for cord

usage in some foreign countries. Use an

attachment plug adaptor of the proper

configuration for power outlet,

ft It requires approximately 8 hours to fully

charge the battery, if the battery capacity is
completely empty. If there is still battery
capacity available, fully charging the battery will

take less time.

ft A fully charged Trimmer has a cordless

trimming time of up to 50 minutes.

B

Disconnect the cord and unplug from

electrical outlet, unless you are using the

Trimmer corded.

NOTE: If the fully charged Trimmer is still con­

nected to the outlet after 30 minutes, the battery
light goes off.

Corded Trimming

O

Connect cord provided to Trimmer.

B

Plug Trimmer into electrical outlet.

B

If battery is completely empty, wait a few

minutes before switching Trimmer on.

D Turn Trimmer ON to begin trimming (fig. 2).

B Turn Trimmer OFF and unplug.

NOTE:Trimmer does not recharge during corded

trimming.

Advertising
This manual is related to the following products: