Philips QT4050-41 - Manual (Page 7)

U Use the Trimmer with the trimming comb
set to a hair length of 1mm/1/32 in. to create
a ‘stubble’ look (fig. 7).
If you want even shorter stubble, use the Trimmer
without the trimming comb attached.
Trimming For 'Stubble' Look
Trimming Without Trimming Comb
Remove trimming comb if you are:
k Defining hair lines
I Trimming nape of neck or full beards
I Removing single, unwanted hairs
U Be certain Trimmer is in the OFF position.
Q Remove the trimming comb by pulling it off
the Trimmer (fig. 8).
Never pull off the Guide Comb Attachment bv
grasping the flexible top portion. Always pull off by
the bottom part of attachment.
B Turn the Trimmer ON.
□ Make well-controlled movements.Touch the
hair lightly with the Trimmer.
Replacing Guide Comb Attachment
On Trimmer
U Be certain Trimmer is in OFF position.
B Replace Guide Comb Attachment until it
‘clicks’ into position.The Guide Comb
Attachment can be placed on Trimmer only
one way by properly aligning it to slide into
the tracks on sides ofTrimmer head. If it
does not fit properly, reverse it.
NQTE:The Zoom Lock can be on any setting
when removing or replacing Attachment.
Cleaning
I Always turn Trimmer OFF before cleaning.
I Do not use abrasive cleaning agents,
scourers or aggressive liquids such as alcohol,
benzene, bleach or acetone to clean the
Trimmer.
i Never clean, remove or replace trimming comb
with motor ON.
I Do not apply pressure to cutters.
i Do not touch cutters with hard objects as this
may damage them.
I Do not use while bathing, showering or
immerse the Trimmer in water or other liquids
as damage to Trimmer may occur.
I Never use sharp or hard objects to clean the
filter to avoid damaging it.
I If cut hairs have accumulated in the trimming
comb area, turn Trimmer off, pull trimming
comb offTrimmer and remove hairs by
shaking and/or blowing.
Hair Collection Chamber
B Turn the Trimmer OFF.
B
Open the lid of the Hair Collection
chamber (fig. 9).
B
Remove the hairs by carefully shaking them
out or by brushing them out with the
cleaning brush supplied (fig. lO).
□ Clean the filter inside the hair collection
chamber with the cleaning brush (fig. I I).
B
Close the lid of the hair collection chamber.
I When trimming extremely long, dense beards,
it may be necessary to empty the Hair
Collection Chamber during the trimming
session in order to maintain optimal suction
performance.
I If suction performance is not as strong as usual.
Hair Collection Chamber may require
emptying to restore optimal performance.
I It is recommended that the Hair Collection
Chamber be emptied and cleaned out after
each use.
I Do not operate the Trimmer with the Hair
Collection Chamber cover opened.