Cuisinart CLEANWATER WCH-950C - Manual (Page 2)


Important
SafeguardS
When using an electrical appliance, basic
precautions should always be followed to
reduce the risk of fire, electric shock, and
personal injury, including the following:
1. Use this appliance only as described in this
manual. Other uses not recommended may
cause fire, electric shock or personal injury.
2. This product is intended for household use
only.
3. To protect against electric shock, do not
immerse unit, plug or cord in water or spray
with liquids.
4. Close supervision is necessary when any
appliance is used by or near children.
5. Unplug from the outlet when not in use or
when moving from one location to another,
and before cleaning.
6. To disconnect the appliance, grip the plug
and pull it from the wall outlet. Never pull
by the cord.
7. Do not operate the appliance in the
presence of explosive and/or flammable
fumes.
8. Do not place the appliance or any of its
parts near an open flame, cooking or other
heating appliance.
9. Do not operate the appliance with a
damaged cord or plug, if the product
malfunctions, or if it is dropped or damaged
in any manner.
10. The use of attachments not recommended
by the manufacturer may be hazardous.
11. Place the unit on a dry level surface.
12. Do not operate if the housing is removed or
damaged.
13. A loose fit between the AC outlet
(receptacle) and plug may cause
overheating and a distortion of the plug.
Contact a qualified electrician to replace
loose or worn outlet.
14. This appliance is designed to be
freestanding only, and should not be
recessed or built in (fully recessed).
15. Locate the unit away from direct sunlight
and sources of heat (stove, heater, radiator,
etc.). Direct sunlight will affect/alter the
outside colour of the appliance.
16. Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection before
or after the system. Individuals requiring
water of specific microbiological purity
should consult their physician.
NOTE: The system and installation of this
product needs to comply with state and local
laws and regulations.
WARNING: To reduce the risk of fire,
electric shock or personal injury, unplug or
disconnect the appliance from the power
supply before servicing.
SaVe tHeSe
InStruCtIonS
for HouSeHoLd
uSe onLY
SPECIAL CORD SET
INSTRUCTIONS
For your protection, this unit
is equipped with a
3-conductor cordset that has
a molded 3-prong
grounding-type plug,
and should be used in
combination with a properly
connected grounding-type
outlet as shown in figure A. If
a grounding-type outlet is
not available, an adapter,
shown in Figure B, may be
obtained so that a
2-slot wall outlet can be used
with a 3-prong plug. As
shown in Figure C, the
adapter must be grounded
by attaching its grounding
lug under the screw of the
outlet cover plate.
NOTE: Do not remove the
grounding prong.
CAUTION: Before using an adapter, it must be
determined that the outlet cover plate screw is
properly grounded. If in doubt, consult a
licensed electrician. Never use an adapter
unless you are sure it is properly grounded.
NOTE: Use of an adapter is not permitted
in Canada.