Produits Neptune 3648 KARMA - Manual (Page 7)

8
D
C
°6mm Drill
A
B
E
STEP 8 Door guide installation
Remove the protective ribbon of double backed tape under the
door guide and position at the end of the fixed glass panel.
Tighten the blockage screw inside.
In the case of a base made of porous material (stone, slate,
etc.) temporarily place the door guide at the end of the fixed
glass panel and mark the drilling position on the base.
Remove the door guide and drill the base at marked location
with the appropriate drill bit.
Secure it to the base with the provided plugs and screws.
F G
9
H
STEP 9 Threshold installation
Take measurement between the door guide and the fixed side
panel and cut the threshold at this length.
Make sure to protect the threshold with masking tape before
cutting it, making sure not to damage the chrome finish.
Apply a thin bead of silicone to its underside and position it on
the base aligned with the fixed glass panel.
Keep the threshold in place with masking tape.
STEP 10 Door swipe and wheel installation on door panel
Place door swipe #30 under the door, lip towards shower interior.
Align to the edge of the glass panel situated against the return
glass panel side and trim the excess.
Position the wheel on the front of the panel (Figure 10) placing a
metal ring and a plastic washer between the wheel and the glass.
Screw from inside, verify for proper integration of the plastic nut
inside the hole of the glass panel making sure the wheel is as
low as possible on the door (turn the white plastic nut for this
adjustment).
Firmly screw and repeat the operation with the second wheel.
30
10