Produits Neptune 3648 KARMA - Manual (Page 8)

12 STEP 12 Blocking cylinders installation
Position one of the blocking cylinders on the door panel
placing a plastic washer in between the metal and the glass.
Screw from inside, verify for proper integration of the plastic
nut inside the hole of the glass panel, making sure the cylin-
der is as high as possible on the door (turn the white plastic
nut for this ajustment).
Firmly tighten making sure not to unsettle the cylinder posi-
tion and repeat operation with the second cylinder.
STEP 13 Waterproof gasket installation
Groove 4 3/4'’ (120mm) on top of the gasket #12 (Figure 13) and install it at the end of the fixed panel. Position the waterproof gasket
#24, at the end of the door panel on the side of the return glass panel in junction with the door swipe.
13
12
24
STEP 11 Door panel installation
Position the door panel on the support bar.
Make sure the wheels are well rested on the bar and integrate
the panel into the door guide.
Slide the door panel towards the fixed side panel and verify
alignment.
If needed, to correct the alignment, slightly loosen the wheels
and, while supporting the weight of the door on the wheels
(one at a time), turn the white plastic nuts with the provided
plastic wrench until the door is well aligned.
Firmly screw the wheels, ensuring not to unsettle the door lev-
el.
11
Intérieur
4 3/4'’