Kenton Linndrum Mk1 Late - Manual (Page 2)

You can also set channels etc on the Linn itself as described below
The top row of nine buttons (Conga thru cabasa) are for selection of
Midi channels - the first 8 are numbers 1 to 8, the ninth button
(cabasa) will add 8 to the channel if pressed immediately prior to
one of the buttons 1 to 8, allowing selection of channels 9 to 16. >>
On the bottom row, Conga selects Receive chan, Tom selects Transmit
chan, SNARE selects [omni-on mode], BASS selects [omni-off mode],
HI-HAT selects [disable midi stop/start in & out], Cowbell selects
[enable midi stop/start in & out], Rimshot and TAMB are not used,
and CABASA is the Enter key, to return you to the normal operating
state.
So the sequence of events is :- Red push button - (then optionally
omni on or off) - then recieve or transmit select, then a channel
number [1 thru 16] - then press bottom row CABASA to exit.
As an example - to get transmit channel 5 and receive channel 10, but
leave it in omni-off mode.
1) Press the red button
2) Press Tom-lo [bottom row of buttons] (transmit select)
3) Press hihat [top row of buttons (transmit ch 5 now set)
4) Press Conga-lo [bottom row of buttons] (receive select)
5) Press cabasa [top row ] (add 8 to the following channel)
6) Press Tom-hi [top row ] [receive ch 10 now set]
7) Press CABASA [bottom row ] - Enter key
Note that when the red button has been pressed, the panel buttons
will not make sounds when pressed, until the Enter key has been
pressed (CABASA [bottom row]).
OPERATION OF DRUM BUTTONS IN SET-UP MODE
------ ------ ------ ------ ------ ------ ------ ------ ------
| Chan | Chan | Chan | Chan | Chan | Chan | Chan | Chan | Add 8|
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | to |
| (9) | (10) | (11) | (12) | (13) | (14) | (15) | (16) | Chan |
------ ------ ------ ------ ------ ------ ------ ------ ------
------ ------ ------ ------ ------ ------ ------ ------ ------
| RX | TX | Omni | Omni | Dis- | En- | Not | Not | |
| | | | | able | able | | |ENTER |
| mode | mode | ON | OFF | START & STOP| used | used | |
------ ------ ------ ------ ------ ------ ------ ------ ------
N.B. - Assign mode cannot be used from the front panel buttons